source: trunk/hal/tsar_mips32/drivers/soclib_nic.c @ 579

Last change on this file since 579 was 570, checked in by alain, 5 years ago

Introduction of the soclib_mty driver for the TSAR-LETI architecture.

File size: 11.0 KB
Line 
1/*
2 * soclib_nic.c - SOCLIB_NIC (Network Interface Controler) driver implementation.
3 *
4 * Author     Alain Greiner (2016)
5 *
6 * Copyright (c) UPMC Sorbonne Universites
7 *
8 * This file is part of ALMOS-MKH.
9 *
10 * ALMOS-MKH.is free software; you can redistribute it and/or modify it
11 * under the terms of the GNU General Public License as published by
12 * the Free Software Foundation; version 2.0 of the License.
13 *
14 * ALMOS-MKH.is distributed in the hope that it will be useful, but
15 * WITHOUT ANY WARRANTY; without even the implied warranty of
16 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the GNU
17 * General Public License for more details.
18 *
19 * You should have received a copy of the GNU General Public License
20 * along with ALMOS-MKH.; if not, write to the Free Software Foundation,
21 * Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
22 */
23
24#include <hal_kernel_types.h>
25#include <hal_remote.h>
26#include <hal_special.h>
27#include <chdev.h>
28#include <dev_nic.h>
29#include <kmem.h>
30#include <printk.h>
31#include <memcpy.h>
32#include <thread.h>
33#include <soclib_nic.h>
34
35///////////////////////////////////////
36void soclib_nic_init( chdev_t * chdev )
37{
38    uint32_t    i;
39    kmem_req_t  req;
40
41    // set driver specific fields in chdev descriptor
42    chdev->cmd = &soclib_nic_cmd;
43    chdev->isr = &soclib_nic_isr;
44   
45    // get hardware device cluster and local pointer
46    cxy_t      nic_cxy  = GET_CXY( chdev->base );
47    uint32_t * nic_ptr  = (uint32_t *)GET_PTR( chdev->base );
48
49    // initialize Soclib NIC global registers
50    hal_remote_s32( XPTR( nic_cxy , nic_ptr + NIC_GLOBAL_SPAN + NIC_G_BC_ENABLE ) , 0 );
51    hal_remote_s32( XPTR( nic_cxy , nic_ptr + NIC_GLOBAL_SPAN + NIC_G_RUN       ) , 0 );
52
53    // allocate memory for chbuf descriptor (one page)
54    assert( (sizeof(nic_chbuf_t) <= CONFIG_PPM_PAGE_SIZE ) ,
55            "chbuf descriptor exceeds one page" );
56
57    req.type   = KMEM_PAGE;
58    req.size   = 0;
59    req.flags  = AF_KERNEL;
60
61    nic_chbuf_t * chbuf = (nic_chbuf_t *)kmem_alloc( &req );
62
63    assert( (chbuf != NULL) ,
64             "cannot allocate chbuf descriptor" );
65
66    // initialise chbuf state
67    chbuf->cont_id  = 0;
68    chbuf->pkt_id   = 0;
69    chbuf->word_id  = 34;
70   
71    // allocate containers (one page per container)
72    // and complete chbuf descriptor initialization
73    assert( (CONFIG_PPM_PAGE_SIZE == 4096) ,
74            "chbuf container must be 4 Kbytes" );
75
76    for( i = 0 ; i < CONFIG_NIC_CHBUF_DEPTH ; i++ )
77    {
78        uint32_t * container = (uint32_t *)kmem_alloc( &req );   
79
80        assert( (container != NULL) ,
81                "cannot allocate container" );
82       
83        chbuf->cont[i] = container;
84        chbuf->full[i] = (paddr_t)XPTR( local_cxy , container );
85    }
86} // end soclib_nic_init()
87
88
89//////////////////////////////////////////////////////////////////
90void __attribute__ ((noinline)) soclib_nic_cmd( xptr_t thread_xp )
91{
92    uint32_t       cmd;          // command type   
93    char         * buffer;       // pointer on command buffer   
94    uint32_t       length;       // Ethernet packet length
95    xptr_t         dev_xp;       // extended pointer on NIC device
96    nic_chbuf_t  * chbuf;        // pointer on chbuf descriptor
97    uint32_t       cont_id;      // index of current container in chbuf
98    uint32_t       pkt_id;       // index of current packet in container
99    uint32_t       word_id;      // index of first word of current packet in container
100    uint32_t     * container;    // pointer on container (array of uint32_t)
101    uint16_t     * header;       // pointer on container header (array of uint16_t)
102    uint32_t       npackets;     // number of packets in current container
103
104    // get local pointer for client thread
105    thread_t * thread_ptr = (thread_t *)GET_PTR( thread_xp );
106
107    // get command arguments
108    cmd    = thread_ptr->nic_cmd.cmd;
109    buffer = thread_ptr->nic_cmd.buffer;
110    length = thread_ptr->nic_cmd.length;
111    dev_xp = thread_ptr->nic_cmd.dev_xp;
112
113    // get local pointer for device
114    chdev_t * dev_ptr = (chdev_t *)GET_PTR( dev_xp );
115
116    // get chbuf descriptor pointer
117    chbuf = (nic_chbuf_t *)dev_ptr->ext.nic.queue;
118
119    // analyse command type
120    switch( cmd )
121    {
122        /////////////////////////////////////////////////////////////////////////////
123        case NIC_CMD_READ:   // transfer one packet from RX queue to command buffer
124        {
125            // get current container index
126            cont_id = chbuf->cont_id;
127           
128            assert( chbuf->full[cont_id] == 0 , "Read an empty container\n" );
129
130            // get pointer on container and header
131            container = chbuf->cont[cont_id];
132            header    = (uint16_t *)container;
133
134            // get  expected packet index and first word index in container
135            pkt_id  = chbuf->pkt_id;
136            word_id = chbuf->word_id;
137
138            // get packet length and number of packets from container header
139            length    = header[pkt_id + 2];
140            npackets  = header[0];
141
142            assert( pkt_id >= npackets,
143                "Read a non readable container, packet index too large\n");
144
145            // move the packet from container to buffer
146            memcpy( buffer , container + word_id , length );
147
148            // update current packet index and first word index
149            chbuf->pkt_id  = pkt_id + 1;
150            if( length & 0x3 ) chbuf->word_id = word_id + (length>>2) + 1;
151            else               chbuf->word_id = word_id + (length>>2);
152        }
153        break;    // end READ
154           
155        //////////////////////////////////////////////////////////////////////////
156        case NIC_CMD_WRITE:  // move one packet from command buffer to TX queue
157        {
158            // get current TX container indexes
159            cont_id = chbuf->cont_id;
160            pkt_id  = chbuf->pkt_id;
161            word_id = chbuf->word_id;
162
163            assert( chbuf->full[cont_id] != 0, "Write to a full container\n" );
164
165            // get pointer on container and header
166            container = chbuf->cont[cont_id];
167            header    = (uint16_t *)container;
168
169            assert( length > ((1024 - word_id) << 2),
170                "Write to a non writable container, packet length too large\n");
171
172            // update packet length in container header
173            header[pkt_id + 2] = (uint16_t)length;
174
175            // move the packet from buffer to container
176            memcpy( container + word_id , buffer , length );
177
178            // update current packet index and first word index
179            chbuf->pkt_id  = pkt_id + 1;
180            if( length & 0x3 ) chbuf->word_id = word_id + (length>>2) + 1;
181            else               chbuf->word_id = word_id + (length>>2);
182        }
183        break;  // end WRITE
184
185        ////////////////////////////////////////////////////////////////////////////
186        case NIC_CMD_WRITABLE:  // analyse chbuf status / update status if required
187        {
188            // get current container state
189            cont_id = chbuf->cont_id;
190            word_id = chbuf->word_id;
191
192            // compute current container writable
193            bool_t ok = ( chbuf->full[cont_id] == 0 ) &&
194                        ( length <= ((1024 - word_id)<<2) );
195
196            if( ok )                // current container writable
197            {
198                // return chbuf writable
199                thread_ptr->nic_cmd.status = true;
200            }
201            else                    // current container not writable
202            {
203                // release current container
204                chbuf->full[cont_id] = 1;
205
206                // check next container
207                cont_id = (cont_id + 1) % CONFIG_NIC_CHBUF_DEPTH;
208
209                if( chbuf->full[cont_id] == 0 ) // next container empty
210                {
211                    // update chbuf status
212                    chbuf->word_id = 34;
213                    chbuf->cont_id = cont_id;
214                    chbuf->pkt_id  = 0;
215                     
216                    // return chbuf writable
217                    thread_ptr->nic_cmd.status = true;
218                }
219                else                            // next container full     
220                {
221                    // return chbuf non writable
222                    thread_ptr->nic_cmd.status = false;
223                }
224            }
225        }
226        break;  // end WRITABLE
227
228        /////////////////////////////////////////////////////////////////////////////
229        case NIC_CMD_READABLE:  // analyse chbuf status / update status if required
230        {
231            // get current container state
232            cont_id  = chbuf->cont_id;
233            pkt_id   = chbuf->pkt_id;
234            npackets = chbuf->cont[cont_id][0] & 0x0000FFFF; 
235           
236            // compute current container readable
237            bool_t ok = ( chbuf->full[cont_id] == 1 ) &&
238                        ( pkt_id < npackets );
239
240            if( ok )                    // current container readable
241            {
242                // return chbuf readable     
243                thread_ptr->nic_cmd.status = true;
244            }
245            else                        // current container non readable
246            {
247                // release current container
248                chbuf->full[cont_id] = 0;
249
250                // check next container
251                cont_id = (cont_id + 1) % CONFIG_NIC_CHBUF_DEPTH;
252
253                if( chbuf->full[cont_id] == 1 ) // next container full
254                {
255                    // update chbuf status
256                    chbuf->word_id = 34;
257                    chbuf->cont_id = cont_id;
258                    chbuf->pkt_id  = 0;
259                     
260                    // return chbuf readable
261                    thread_ptr->nic_cmd.status = true;
262                }
263                else                            // next container empty   
264                {
265                    // return chbuf non readable
266                    thread_ptr->nic_cmd.status = false;
267                }
268            }
269   
270        }
271        break;  // end READABLE
272        default: {
273            assert( false, "Unknown command <%x>\n", cmd );
274        }
275    }
276} // end soclib_nic_cmd()
277
278
279/////////////////////////////////////////////////////////////////
280void __attribute__ ((noinline)) soclib_nic_isr( chdev_t * chdev )
281{
282    // get base, size, channel, is_rx from NIC channel device NIC
283    xptr_t     base    = chdev->base;
284    uint32_t   channel = chdev->channel;
285    bool_t     is_rx   = chdev->is_rx;
286
287    // get NIC peripheral cluster and local pointer
288    cxy_t      cxy_nic = GET_CXY( base );
289    uint32_t * ptr_nic = (uint32_t *)GET_PTR( base );
290
291    // compute local pointer on status register
292    uint32_t * offset;
293    if( is_rx ) offset = ptr_nic + (NIC_CHANNEL_SPAN * (channel + 1)) + NIC_RX_STATUS;
294    else        offset = ptr_nic + (NIC_CHANNEL_SPAN * (channel + 1)) + NIC_TX_STATUS;
295
296    // read NIC channel status and acknowledge IRQ
297    uint32_t status = hal_remote_l32( XPTR( cxy_nic , offset ) );
298
299    assert( status != 0, "Illegal address: \n" );
300
301    // unblock server thread
302    thread_t * server = chdev->server;
303    thread_unblock( XPTR( local_cxy , server ) , THREAD_BLOCKED_IO );
304
305} // end soclib_nic_isr()
306
307
308
Note: See TracBrowser for help on using the repository browser.